DIY Programmable Power-Supply for Vacuum Tubes – Part 1

Preface: up until now, all posts I’ve shared were completed in a single post. This was due to the fact I’ve waited until I was done with it and only then posted. This allowed me to assemble/verify (when needed), and was much more comprehensive for readers. However, lately I’m finding it more difficult to find the time to cross items off my “diy to-do” list. Quite a few items get stuck for long periods of time in the design stage, due to lack of time to move it forward and complete the board layout/assembly/testing. Therefore, I’ve decided to gradually post a few of these on the blog as parts of a project. This post will be the first of a few such projects that will be split into several parts. Hopefully, even sharing partial information such as schematics will prove useful to some readers. </end preface>

One of the items that was on my “wish-list” for quite some time is a programmable power-supply (PS) that will be fit for work with vacuum tubes. The main reason I need it is because I’m missing is a high-voltage PS that can reach as high as 400V or even higher. Therefore, this was the main objective of the design I will present in this post. However, seeing as most transformers that are intended for these uses include a low voltage secondary winding for the heaters, it makes sense to have another channel that can supply the heater rail too.

Continue reading “DIY Programmable Power-Supply for Vacuum Tubes – Part 1”